Next: Sigaction Function Example, Previous: Advanced Signal Handling, Up: Signal Actions [Contents][Index]
signal
and sigaction
It’s possible to use both the signal
and sigaction
functions within a single program, but you have to be careful because
they can interact in slightly strange ways.
The sigaction
function specifies more information than the
signal
function, so the return value from signal
cannot
express the full range of sigaction
possibilities. Therefore, if
you use signal
to save and later reestablish an action, it may
not be able to reestablish properly a handler that was established with
sigaction
.
To avoid having problems as a result, always use sigaction
to
save and restore a handler if your program uses sigaction
at all.
Since sigaction
is more general, it can properly save and
reestablish any action, regardless of whether it was established
originally with signal
or sigaction
.
On some systems if you establish an action with signal
and then
examine it with sigaction
, the handler address that you get may
not be the same as what you specified with signal
. It may not
even be suitable for use as an action argument with signal
. But
you can rely on using it as an argument to sigaction
. This
problem never happens on GNU systems.
So, you’re better off using one or the other of the mechanisms consistently within a single program.
Portability Note: The basic signal
function is a feature
of ISO C, while sigaction
is part of the POSIX.1 standard. If
you are concerned about portability to non-POSIX systems, then you
should use the signal
function instead.